Cutting Board Juice Groove. First time doing a cutting board. Any tips on finishing? Juice groove or no? r/woodworking Tilt it to the side, wait for the bit to reach full speed, and slowly lower the router bit into the piece Cutting boards are a staple in every kitchen, serving as both a platform for chopping and a key player in efficient culinary operations
DIY Cutting board juice groove jig — Walker's Woodworks from www.walkersww.com
Step 2: Mark the groove's location on the cutting board Using a pencil and a ruler or measuring tape, measure and mark the desired location for the juice groove on the cutting board's surface
DIY Cutting board juice groove jig — Walker's Woodworks
A router is a power tool that will be used to create the juice groove. If youve ever dealt with a cutting board that lacks a juice groove, youre likely familiar with the chaos that ensues when juices run off the edge, creating a mess and disrupting your workflow. The groove should be about 1/4 inch deep and 3/8 inch wide.
DIY Cutting board juice groove jig — Walker's Woodworks. The dimension will result in a groove that is centered 1 inch from the edge of the cutting board Cutting boards are a staple in every kitchen, serving as both a platform for chopping and a key player in efficient culinary operations
3D Plans for Cutting Board Juice Groove Jig King's Fine Woodworking Inc. Tilt it to the side, wait for the bit to reach full speed, and slowly lower the router bit into the piece So as not to leave a thin wall between the inside edge of the handle and the blood groove runner, yet leave a pleasing even aesthetic look to the surface while maximizing the cutting area, I decided to measure in 1-3/8″ for the runner wall edge, leaving.